Safeguard Audit Service Manual (G06.24+, H06.03+)

SAFEART Error Messages
Safeguard Audit Service Manual—520480-014
8-6
Cause. The new SAFEART prompt you defined with a DISPLAY PROMPT command
is longer than 80 characters.
Effect. The DISPLAY PROMPT command is not executed.
Recovery. Reenter the command using a shorter prompt definition. (Use fewer
parameters or a shorter character string within parentheses.)
Cause. Enough errors were found in a SET WHERE command to prevent SAFEART
from using it.
Effect. The SET WHERE command is not executed.
Recovery. Reenter the SET WHERE command, correcting the errors described by
other error messages.
Cause. The command contains a syntax error.
Effect. The command is not executed.
Recovery. Reenter the command using the correct syntax.
Cause. The number of lines you asked to be displayed by a HISTORY command is
greater than 9999.
Effect. The HISTORY command is not executed.
Recovery. Reenter the command using a value of 9999 or less.
Cause. The text for a SET TITLE command was longer than 100 characters.
Effect. Processing ends, and you are returned to the SAFEART prompt.
Recovery. Reenter the command with a shorter character string.
ERROR: Prompt string must be 80 characters or less.
ERROR: SET WHERE ignored.
ERROR: Syntax error.
ERROR: This number must be less than or equal to 9999.
ERROR: Title lines must be 100 characters or less.