Safeguard Audit Service Manual (G06.24+, H06.03+)

SAFEART Error Messages
Safeguard Audit Service Manual—520480-014
8-8
Cause. An event was not used because of an error in the audit file, identified by
error-number. error-number is in one of these ranges:
Effect. SAFEART continues processing with the next event in the audit file.
Recovery. Many errors of this type suggest a badly damaged audit file or series of
files. Try rerunning with a backup version of the audit files. A low number of these
errors indicates primary and secondary records split between two audit files. In this
case, if the missing event is important, rerun the report with the appropriate additional
audit file or files defined in the AUDIT FILE command.
Cause. MINPASSWORDLEN attribute is greater than MAXPASSWORDLEN, when
ENCRYPTPASSWORD is ON and PASSWORD-ALGORITHM is HMAC256.
Effect. Command not executed.
Recovery. MINPASSWORDLEN attribute should be greater than or equal to
MAXPASSWORDLEN.
Cause. MINPASSWORDLEN attribute is greater than eight, when
ENCRYPTPASSWORD is OFF or, ENCRYPTPASSWORD is ON and
PASSWORD-ALGORITHM is DES.
Effect. Command not executed.
Recovery. MINPASSWORDLEN attribute should be less than or equal to eight.
WARNING error-number Event Flushed
10 - 49 A link from a primary to secondary record is damaged.
52 - 57 A secondary record has no primary record. The error-number is the
record type.
102 An incomplete primary record is incomplete. Some of the secondary
records are missing.
ERROR: THIS NUMBER MUST BE LESS THAN OR EQUAL TO MAXPASSWORDLEN; COMMAND
NOT EXECUTED.
Note. This error message is supported only on systems running H06.08 and later H-series
RVUs.
ERROR: THIS NUMBER MUST BE LESS THAN OR EQUAL TO 8; COMMAND NOT EXECUTED.
Note. This error message is supported only on systems running H06.08 and later H-series
RVUs.