Safeguard Audit Service Manual (G06.24+, H06.03+)

Getting Started With SAFEART
Safeguard Audit Service Manual—520480-014
5-2
Running SAFEART
Running SAFEART
To run SAFEART interactively, at your command interpreter prompt:
2>SAFEART
Safeguard Audit File Reduction Tool T9750D30
<=
SAFEART displays a default prompt of <= while you are in a SAFEART session. Enter
all SAFEART commands at this prompt. You can run as many reports as you want in
one session. To end a SAFEART session and return to your command interpreter,
enter the EXIT command.
To run SAFEART in batch mode, enter SAFEART commands in a file and then execute
the commands with an OBEY command during a SAFEART session. Alternatively, you
can specify the file as an IN option when you run SAFEART from your command
interpreter.
The format of the SAFEART run command is:
The SAFEART run options are the same as the SAFECOM run options described in
the Safeguard Reference Manual.
For example, to run the SAFEART commands in the $DATA.SECURITY.REPORT2 file
in batch mode:
4>SAFEART /IN $data.security.report2, NOWAIT/
From within a SAFEART session:
<=OBEY $data.security.report2
Command Rules
The rules governing the use of SAFEART commands are generally the same as the
rules governing SAFECOM commands.
Using Quotation Marks
Character strings used for various command parameters can contain any printable
ASCII character. If a string contains commas or spaces, the string must be enclosed in
single (') or double (") quotation marks. If a string contains single quotation marks,
enclose the string must in double quotation marks. If a string contains double quotation
marks, enclose the string in single quotation marks. A string cannot contain both single
and double quotation marks.
If a user ID is specified as a command parameter, it cannot be enclosed in quotation
marks.
SAFEART [ / run-opt [ , run-opt ] ... / ]