Safeguard Management Programming Manual (G06.29+, H06.08+, J06.03+)

Commands
Safeguard Management Programming Manual—422086-028
7-110
ALTER SUBSYSTEM Command
ZSFG-TKN-CHECK-PAT-DISKFILE
is an optional token that enables, disables, and determines the search order for
disk file patterns. The default value is OFF. The defined values are:
ZSFG-TKN-AUD-CLIENT-OSS
is an optional token that enables and disables the writing of OSS related audit
records to the audit trail. The default is ZSPI-VAL-TRUE.
ZSFG-VAL-CHECK-PAT-FIRST specifies that pattern searching will occur first,
and if and only if the result is NORECORD
then the normal search for a protection record
will occur.
ZSFG-VAL-CHECK-PAT-LAST specifies that pattern searching will occur after
the normal search if and only if the normal
search result is NORECORD.
ZSFG-VAL-CHECK-PAT-OFF specifies that no pattern searches will occur.
ZSFG-VAL-CHECK-PAT-ONLY specifies that only pattern searching occurs.
That is, normal non-pattern searching will not
be performed even if the pattern search
returns NORECORD.
ZSFG-VAL-CHECK-PAT-MID specifies that pattern based protection records
will be searched:
•
After the diskfile protection record search
returns NORECORD when DIRECTION-
DISKFILE is set to Filename-First.
•
Before the diskfile protection record
search, when the DIRECTION-DISKFILE
is set to VOLUME-FIRST, and VOLUME
and SUBVOLUME protection record
search returns NORECORD.
Note. The ZSFG-TKN-CHECK-PAT-DISKFILE token is supported only on systems
running J06.08 and later J-series RVUs and H06.18 and later H-series RVUs.
Note. The ZSFG-TKN-AUD-CLIENT-OSS token is supported only on systems running
H06.08 and later H-series RVUs and G06.29 and later G-series RVUs.