Safeguard Management Programming Manual (G06.29+, H06.08+, J06.03+)

Commands
Safeguard Management Programming Manual—422086-028
7-140
DELETE EVENT-EXIT-PROCESS (PROC)
Command
ZCOM-ERR-FS-ERR
is returned when a file-system error occurs. The file-system error list describes
the file-system error, the file-system procedure, and the file in question.
ZCOM-ERR-NO-MEM-SPACE
is returned when the Security Manager Process (SMP) cannot obtain memory
to service the DELETE request. Normally, this error should not occur, and it
should be transient if it does occur.
ZCOM-ERR-OBJ-NOT-FOUND
is returned if the specified event exit ZCOM-TKN-OBJNAME does not exist.
ZCOM-ERR-OBJNAME-INV
is returned if the specified event exit ZCOM-TKN-OBJNAME is not valid.
ZCOM-ERR-SECUR-VIOL
is returned if the requestor's process access ID does not have authority to
execute the DELETE EVENT-EXIT-PROCESS. For the rules for who can
manage the event exit, see the Safeguard Reference Manual.
ZCOM-ERR-SPI-ERR
is returned if one of the procedures (for example, SSGETTKN) returned an
error. The SPI error list defines the procedure in error, the error status, and the
token involved.
ZCOM-ERR-TKN-CODE-INV
is returned if an invalid, foreign, or unsupported token was found. The error list
identifies the invalid token.
ZCOM-ERR-SSID-INV
is returned if the subsystem ID is in error. The error list identifies the invalid
subsystem ID.
ZCOM-ERR-VSN-INCOMP
is returned when the version of the command is greater than the subsystem
version and the command contains unknown tokens. Or a field in a structured
token is greater than the subsystem version. The error list contains the
subsystem version.
ZSFG-ERR-PROC-ENABLED
is returned if an attempt is made to delete the event-exit process when it is
enabled.