Safeguard Management Programming Manual (G06.29+, H06.08+, J06.03+)

Commands
Safeguard Management Programming Manual—422086-028
7-34
ADD GROUP Command
Command-Specific Tokens in the Command Buffer
Unless otherwise stated, multiple occurrences of these tokens are not allowed.
ZSPI-TKN-MANAGER
ZSPI-TKN-MAXRESP
ZSPI-TKN-RESPONSE-TYPE
ZSPI-TKN-ALLOW-TYPE
ZSPI-TKN-COMMENT
are common standard tokens documented in the SPI Programming Manual.
ZCOM-TKN-OBJNAME
is a required token that contains the group name of the new group to be added.
ZSFG-MAP-OWNERID
is an optional structured token that specifies the owner of the group record being
added. It contains these fields:
ZTYPEID
specifies the type of user ID defined by ZGROUPNUM and ZUSERNUM. This
field must contain one of these values:
ZSFG-VAL-TYPEID-LOCALSPECIFIC
ZSFG-VAL-TYPEID-REMOTESPECIFIC
ZGROUPNUM
is the group number portion of the owner ID.
ZUSERNUM
is the member number portion of the owner ID.
ZSFG-TKN-GROUPID
is a required token that contains the group number associated with the group name
to be added. The number must be in the range from 0 through 65535 and must not
belong to any existing group.
Note. Group numbers 65536 through 65567 are special groups, where 65536 is the
SECURITY-ENCRYPTION-ADMIN group and 65537 through 65567 are reserved for future
use by HP.
Note. This is supported only on systems running J06.08 and later J-series RVUs and
H06.18 and later H-series RVUs.