Safeguard Reference Manual (G06.24+, H06.03+ )

Disk Volume and Subvolume Security Commands
Safeguard Reference Manual—520618-013
9-32
SHOW VOLUME and SUBVOLUME Commands
Also, the Safeguard software audits successful attempts to manage the subvolume
authorization record:
=ASSUME SUBVOLUME
=SET ACCESS 86,* c; 86,8 DENY c
=SET AUDIT-MANAGE-PASS all
=SHOW
The display shows:
SHOW VOLUME and SUBVOLUME Commands
SHOW VOLUME displays the current default values for the volume attributes. SHOW
SUBVOLUME displays the current default values for the subvolume attribute.
When you add a volume authorization record, the default volume attribute values are
used for any attributes you do not specify in the ADD VOLUME command. Similarly,
when you add a subvolume authorization record, the default subvolume attribute
values are used for any attributes you do not specify in the ADD SUBVOLUME
command.
OUT listfile
directs the SHOW VOLUME or SHOW SUBVOLUME report to listfile. After
you execute the SHOW command, SAFECOM redirects output to the current OUT
file.
For listfile, specify any file name. SAFECOM opens listfile and appends
the SHOW report to the file. If listfile does not exist, SAFECOM creates an
EDIT-format file and writes the SHOW report to that file.
SHOW VOLUME and SUBVOLUME Report Format
Figure 9-3 on page 9-33 illustrates the format for the SHOW VOLUME and SHOW
SUBVOLUME command display.
TYPE OWNER WARNING-MODE
SUBVOLUME 86,2 OFF
AUDIT-ACCESS-PASS = NONE AUDIT-MANAGE-PASS = ALL
AUDIT-ACCESS-FAIL = NONE AUDIT-MANAGE-FAIL = NONE
086,008 DENY C
086,* C
SHOW [ / OUT listfile / ] { VOLUME | SUBVOLUME }