Safeguard Reference Manual (G06.24+, H06.03+ )

Security Group Commands
Safeguard Reference Manual—520618-013
13-20
SET SECURITY-GROUP Command
A brief report shows:
To restore the default group ACL to its predefined value (that is, no ACL):
=RESET SECURITY-GROUP ACCESS
To display the new attribute values:
=SHOW SECURITY-GROUP
A brief report shows:
SET SECURITY-GROUP Command
SET SECURITY-GROUP establishes default values for one or more security group
attributes. These default values become a template so that when you add an
authorization record for a security group, the default values are used for any attributes
not specified in your ADD SECURITY-GROUP command.
To display the current default security group attribute values, use the SHOW
SECURITY-GROUP command.
LIKE sec-group-spec
sets the current default sec-group-attribute values to the existing sec-
group-spec values.
TYPE OWNER
SECURITY-GROUP \*.86,255
AUDIT-ACCESS-PASS = ALL AUDIT-MANAGE-PASS = REMOTE
AUDIT-ACCESS-FAIL = NONE AUDIT-MANAGE-FAIL = ALL
255,255 E,O
\*.086,255 E,O
086,* E,O
TYPE OWNER
SECURITY-GROUP \*.86,255
AUDIT-ACCESS-PASS = ALL AUDIT-MANAGE-PASS = REMOTE
AUDIT-ACCESS-FAIL = NONE AUDIT-MANAGE-FAIL = ALL
NO ACCESS CONTROL LIST DEFINED!
SET SECURITY-GROUP [ , ]
{ LIKE sec-group-spec | sec-group-attribute }
[ , sec-group-attribute ] ...