Safeguard Reference Manual (G06.29+, H06.08+, J06.03+)

User Security Commands
Safeguard Reference Manual — 520618-030
5 - 40
SET USER Command
The report shows:
SET USER Command
SET USER establishes current default values for one or more user attributes. Later,
when you add a user to your system, use these current default user-attribute values
are used for any attribute you do not specify in the ADD USER command.
After you set the current default user-attribute values, use the SHOW USER comman
d
to display the current default user-attribute values before you add a user through ADD
USER.
USER
specifies USER as the object type of the SET command. Omit it if USE
R is the
assumed type. (For more information, see the
ASSUME Command on page 4-3.)
TYPE OWNER
USER 86,255
PASSWORD =
USER-EXPIRES = * NONE *
PASSWORD-EXPIRES = * NONE *
PASSWORD-MUST-CHANGE EVERY = * NONE *
PASSWORD-EXPIRY-GRACE = * NONE *
GUARDIAN DEFAULT SECURITY = OOOO
GUARDIAN DEFAULT VOLUME = $SYSTEM.NOSUBVOL
AUDIT-AUTHENTICATE-PASS = NONE AUDIT-MANAGE-PASS = NONE
AUDIT-AUTHENTICATE-FAIL = NONE AUDIT-MANAGE-FAIL = NONE
AUDIT-USER-ACTION-PASS = NONE
AUDIT-USER-ACTION-FAIL = NONE
TEXT-DESCRIPTION =
CI-PROG = * NONE *
CI-LIB = * NONE *
CI-NAME = * NONE *
CI-SWAP = * NONE *
CI-CPU = ANY
CI-PRI = * NONE *
CI-PARAM-TEXT =
INITIAL-PROGTYPE = PROGRAM
INITIAL-PROGRAM =
INITIAL-DIRECTORY =
SUBJECT DEFAULT-PROTECTION SECTION UNDEFINED!
SUBJECT OWNER-LIST SECTION UNDEFINED!
SET USER [ , ] { LIKE user | user-attribute }
[ , user-attribute ] ...