Safeguard Reference Manual (G06.29+, H06.08+, J06.03+)

Process and Subprocess Security Commands
Safeguard Reference Manual — 520618-030
11 - 3 6
SHOW PROCESS and SUBPROCESS Commands
•
The group manager for group 33 has READ, WRITE, and CREATE access
authorities.
•
Two auditing specifications establish that audit records are written each time any
successful attempt or any local unsuccessful attempt is made to create a process
that has this process name or to open or stop a process running under this process
name.
To specify the process name to have these default attribute values (and to create the
authorization record), use ADD PROCESS.
SHOW PROCESS and SUBPROCESS Commands
SHOW PROCESS or SUBPROCESS displays the current default attribute values.
When you add an authorization record, the current default attribute values are used for
any attributes you do not specify in the ADD PROCESS or SUBPROCESS command.
To set the default attribute values to specific values, use the SET PROCESS or
SUBPROCESS command.
OUT listfile
directs the SHOW PROCESS or SUBPROCESS report to listfile. After
executing the SHOW command, SAFECOM redirects its output to the current OUT
file.
For listfile, specify any file name. SAFECOM opens listfile and appends
the SHOW PROCESS report to the file. If listfile does not exist, SAFECOM
creates an EDIT file and writes the SHOW PROCESS report to that file.
SHOW PROCESS and SUBPROCESS Report Format
The SHOW PROCESS command displays the current default attribute values in the
format shown in Figure
11-3. The SHOW SUBPROCESS command output is similar,
except that a subprocess name appears in place of a process name.
SHOW [ / OUT listfile / ] { PROCESS | SUBPROCESS }