Safeguard Reference Manual (G06.29+, H06.08+, J06.03+)

Event-Exit-Process Commands
Safeguard Reference Manual — 520618-030
15 - 11
INFO EVENT-EXIT-PROCESS Command
Examples
1. To delete the configuration record for the event-exit process LOGON1:
=DELETE EVENT-EXIT-PROC logon1
INFO EVENT-EXIT-PROCESS Command
The INFO EVENT-EXIT-PROCESS command shows the event-exit attributes stored in
the specified event-exit configuration record. Only one event-exit name can be
specified in an INFO EVENT-EXIT-PROCESS command.
Any user can execute the INFO EVENT-EXIT-PROCESS command.
name
specifies the name of the event-exit process-configuration record for which an
INFO report is to be produced.
INFO EVENT-EXIT-PROCESS Report Format
Figure 15-1 on page 15-11shows the format of the INFO EVENT-EXIT-PROCESS
report.
The report contains these fields:
EVENT-EXIT-PROCESS = name
is the name of the event-exit-process configuration record.
ENABLED = { ON | OFF }
indicates whether the event-exit process is enabled.
INFO EVENT-EXIT-PROCESS name
Figure 15-1. Detailed INFO EVENT-EXIT-PROCESS Report
EVENT-EXIT-PROCESS = name
ENABLED = { ON | OFF }
RESPONSE-TIMEOUT = n SECONDS
TIMEOUT-ALL-AUTHZREQ = { ON | OFF }
ENABLE-AUTHENTICATION-EVENT = { ON | OFF }
ENABLE-AUTHORIZATION-EVENT = { ON | OFF }
ENABLE-PASSWORD-EVENT = { ON | OFF }
PROG = [prog-filename]
LIB = [lib-filename]
SWAP = [$vol[.subvol.filename] ]
PNAME = [process-name]
CPU = {cpu-number \ ANY}
PRI = [priority]
PARAM-TEXT = [startup-param-text]