Safeguard Reference Manual (G06.29+, H06.08+, J06.03+)

Event-Exit-Process Commands
Safeguard Reference Manual — 520618-030
15 - 12
INFO EVENT-EXIT-PROCESS Command
RESPONSE-TIMEOUT = n SECONDS
is the maximum number of seconds that the Safeguard software waits for the
event-exit process to respond to an event.
TIMEOUT-ALL-AUTHZREQ = { ON | OFF }
indicates whether Safeguard will time out while waiting for response from SEEP on
authorization events requested by deniable users.
ENABLE-AUTHENTICATION-EVENT = { ON | OFF }
indicates whether authentication events are sent to the event-exit process.
ENABLE-AUTHORIZATION-EVENT = { ON | OFF }
indicates whether authorization events are sent to the event-exit process.
ENABLE-PASSWORD-EVENT = { ON | OFF }
indicates whether password change events are sent to the event-exit process.
PROG = [ prog-filename ]
is the name of the object file of the event-exit process started when
ENABLED=ON.
LIB = [ lib-filename ]
is the name of the library file used with this event-exit process.
SWAP [ $vol[.subvol.filename] ]
is the name of the volume or file used as the swap volume or swap file for the
event-exit process.
NAME [ process-name ]
is the process name assigned to the event-exit process when it is st
arted.
CPU { cpu-number | ANY }
is the number of the CPU in which the event-exit process runs.
PRI [ priority ]
is the priority at which the event-exit process runs.
PARAM-TEXT [ startup-param-text ]
is the data supplied as the startup message text for the event-exit process.
Note. The TIMEOUT-ALL-AUTHZREQ attribute is supported only on systems running
H06.26 and later H-series RVUs and J06.15 and later J-series RVUs.