Safeguard Reference Manual (G06.29+, H06.08+, J06.03+)

SAFECOM Error and Warning Messages
Safeguard Reference Manual — 520618-030
A - 39
Recovery. Review the valid use of wild-card characters, correct the name, and retry
the command.
Cause. The text string specified for the TEXT-DESCRIPTION attribute in a command
contained nonprintable characters.
Effect. The command is not executed.
Recovery. Remove the nonprintable characters or replace them with printable
characters. The printable characters are:
•
Lowercase letters a through z
•
Uppercase letters A through Z
•
Digits 0 through 9
•
Special characters { } ! @ # $ % ^ & * ( ) - _ + = { } ~ ‘ : ; ? / > . < , .
•
Space
Cause. An attempt to set the TRUST attribute to ME or SHARED for a disk file failed
because the file is not a program object file.
Effect. The command is rejected.
Recovery. None
Cause. PASSWORD-MINIMUM-LENGTH attribute is greater than PASSWORD-
MAXIMUM-LENGTH, when PASSWORD-ENCRYPT is ON and PASSWORD-
ALGORITHM is HMAC256.
Effect. The command is not executed.
Recovery. PASSWORD-MINIMUM-LENGTH attribute should be lesser than or equal
to
PASSWORD-MAXIMUM-LENGTH.
*ERROR* TEXT DESCRIPTION FIELD CONTAINS INVALID CHARACTERS; COMMAND NOT
EXECUTED
Note. The nonprintable characters error message is supported only on systems running
G06.27 and later G-series RVUs and H06.06 and later H-series RVUs.
* ERROR * RECORD FOR DISKFILE filename : TRUST ONLY PROGRAM OBJECT FILES
ERROR: THIS NUMBER MUST BE LESS THAN OR EQUAL TO MAXPASSWORDLEN; COMMAND
NOT EXECUTED.
Note. This error message is supported only on systems running G06.31 and later G-series
RVUs and H06.08 and later H-series RVUs.