SCF Reference Manual for G-Series RVUs (G06.24+)

SCF Commands

SCF Reference Manual for G-Series RVUs—520413-004

5-28

ALLOWOPENS Command

The ALLOWOPENS command allows file opens to be issued to an object. This

command reverses the effect of a STOPOPENS command.

This is a sensitive command.

OUT file-spec

causes any SCF output generated for this command to be directed to the specified

file. The variable file-spec is defined on page 5-9.

object-spec

designates the objects that are allowed to have opens issued to them. The

variable object-spec is defined on page 5-2. You can omit object-spec if it

has been assumed. (See ASSUME Command on page 5-36.)

SUPERONLY

allows only the super ID (255,255) to open a file on the specified object.

SUB [ subobjtype ]

selects the subordinate objects the command affects. The variable subobjtype

can be a subordinate object type or one of the keywords ONLY, ALL, or NONE, as

explained under SCF Subdevices on page 3-5.

SEL [ NOT ] state

directs the command only at objects in the specified state or only at those not in

the specified state. Valid states are listed in Table 3-1 on page 3-7. The use of this

option is subsystem-specific.

Consideration

To stop opens to an object, use the STOPOPENS command (described on

page 5-117).

Examples

•

The following command allows opens to the workstation subdevice $L3.#TERM:

-> ALLOWOPENS WS $L3.#TERM

ALLOWOPENS [ /OUT file-spec/ ] [ object-spec ][ , SUPERONLY ]

[ , SUB [ subobjtype ] ] [ , SEL [ NOT ] state ]