SCF Reference Manual for G-Series RVUs (G06.24+)

SCF Commands

SCF Reference Manual for G-Series RVUs—520413-004

5-73

LISTOPENS Command

The LISTOPENS command displays information about the file opens that apply to the

specified object.

OUT file-spec

causes any SCF output generated for this command to be directed to the specified

file. The variable file-spec is defined on page 5-9.

object-spec

designates the objects whose open information is to be displayed. The variable

object-spec is defined on page 5-2.

SUB [ subobjtype ]

selects the subordinate objects the command affects. The variable subobjtype

can be a subordinate object type or one of the keywords ONLY, ALL, or NONE, as

explained under SCF Subdevices on page 3-5.

SEL [ NOT ] state

directs the command only at objects in the specified state or only at those not in

the specified state. Valid states are listed in Table 3-1 on page 3-7. The use of this

option is subsystem-specific.

The format of the LISTOPENS display is shown below.

LISTOPENS [ /OUT file-spec/ ] object-spec

[ , SUB [ subobjtype ] ] [ , SEL [ NOT ] state ]

subsystem LISTOPENS object-type object-name

OPENERS PPID BPID

object-name nn,nnn nn,nnn …

-or-

\system.nn,nnn nn,nnn nn,nnn …

subsystem The reporting subsystem name

object-type The object type

object-name The fully qualified name of the object.

OPENERS The fully qualified name of the opener process if the opener is a

named process, or the system and the PID of the opener

process if the opener is an unnamed process; otherwise, it is

blank.