SCF Reference Manual for G-Series RVUs (G06.24+)

SCF Commands

SCF Reference Manual for G-Series RVUs—520413-004

5-81

MOVE Command

The MOVE command relocates an object and its subordinates to another location in a

subsystem-defined object hierarchy. The move is horizontal. The object is assigned a

new parent at the same level in the hierarchy. The object itself is not renamed. The

use of this command is subsystem-specific.

This is a sensitive command.

OUT file-spec

causes any SCF output generated for this command to be directed to the specified

file. The variable file-spec is defined on page 5-9.

object-spec

designates the object to be moved. The variable object-spec is defined on

page 5-2. You can omit object-spec if it has been assumed. (See ASSUME

Command on page 5-36.)

target-parent-object

designates the new parent object for the object being moved.

Consideration

If the subsystem supports it, you can use the RENAME command (described on

page 5-97) to change the name of a moved object.

Example

The following command moves the object #SU1 from $LINE to control by $LINE2:

-> MOVE SU $LINE.#SU1, $LINE2

MOVE [ /OUT file-spec/ ] [ object-spec ] ,

target-parent-object