SCF Reference Manual for G-Series RVUs (G06.24+)

SCF Commands

SCF Reference Manual for G-Series RVUs—520413-004

5-99

REPLACE Command

The REPLACE command installs a new version of an object while the object is

executing. The use of this command is subsystem-specific.

This is a sensitive command.

/OUT file-spec/

causes any SCF output generated for this command to be directed to the specified

file. The variable file-spec is defined on page 5-9.

object-spec

designates the object to be replaced. The variable object-spec is defined on

page 5-2. If object-spec is omitted, the assumed object is renamed. For

information about characteristics of the assumed object, see ASSUME Command

on page 5-36.

attribute-spec

specifies an attribute and the value associated with the attribute. The attribute and

its value are defined by the subsystem that supports the REPLACE command.

The variable attribute-spec is defined on page 5-7.

Examples

•

The following command allows online replacement of the TSYSDP2 file in the

storage subsystem while the file is in use:

-> REPLACE $DATA00, PROGRAM $SYSTEM.ZDP2.TSYSDP2

•

The following command replaces the TSYSDP2 file on all magnetic disks in the

system that are in the STOPPED state.

-> REPLACE DISK $*, PROGRAM $SYSTEM.ZDP2.TSYSDP2, &

-> SUB MAGNETIC, SEL STOPPED

•

The following command replaces the $ZZSTO program on all magnetic disks in the

system.

-> REPLACE $ZZSTO, SUB MAGNETIC, COMMIT

REPLACE [ /OUT file-spec/ ] [ object-spec ] ,

attribute-spec