SCF Reference Manual for G-Series RVUs (G06.24+)

SCF Error Messages
SCF Reference Manual for G-Series RVUs—520413-004
B-6
Table-Driven PM Error Messages
00013
Cause. A string, enclosed in quotation marks, is expected after the attribute.
Effect. SCF waits for the next command.
Recovery. Retry the command with a valid string value.
00014
Cause. Either there is no display information defined or the subsystem table is
corrupted.
Effect. SCF waits for the next command.
Recovery. Check the SCF manual for the applicable subsystem. If display information
is specified for this object, save pertinent information and contact your service provider,
as described under If You Have to Call Your Service Provider on page B-2.
00015
Cause. The maximum display length defined by the subsystem has been exceeded.
Effect. The display is truncated to the maximum display length.
Recovery. As described under If You Have to Call Your Service Provider on page B-2,
save pertinent information and contact your service provider.
00016
Cause. The ZsubsysSCF product module cannot process a display of the error
message because it cannot retrieve a value from the response buffer or it detected an
error while processing the error message.
Effect. SCF waits for the next command.
Recovery. As described under If You Have to Call Your Service Provider on page B-2,
save pertinent information and contact your service provider.
TABLPM 00013 A quoted STRING is expected.
TABLPM 00014 No display information is provided for
object-type: object-name.
TABLPM 00015 The maximum display length has been exceeded.
The display will be truncated to the maximum display length.
TABLPM 00016 Cannot display a field in the error message
subsystem-error (scf-error).