SCF Reference Manual for G-Series RVUs (G06.24+)

SCF Error Messages
SCF Reference Manual for G-Series RVUs—520413-004
B-24
SCF Error Messages
20120
Cause. SCF is expecting the named DEFINE to be a search DEFINE.
Effect. SCF waits for the next command.
Recovery. Delete the named DEFINE or change it to type SEARCH.
20121
Cause. A failure has occurred while adding the named DEFINE.
Effect. SCF waits for the next command, or SCF terminates, depending on the
error-num.
Recovery. Refer to the Guardian Procedure Calls Reference Manual for recovery from
the DEFINE error. Then retry the command.
20122
Cause. A failure has occurred while setting attributes for the named DEFINE.
Effect. SCF waits for the next command or SCF terminates, depending on the
error-num.
Recovery. Refer to the Guardian Procedure Calls Reference Manual for recovery from
the DEFINE error. Then retry the command.
20125
Cause. The device’s I/O process (IOP) has been configured improperly. As a result,
the device’s IOP is down and is awaiting a STOP command. A message in the EMS
log should indicate the cause of the configuration error.
Effect. SCF waits for the next command.
Recovery. Stop the device’s IOP, correct the configuration, and restart it.
SCF 20120 define-name is not a search define.
SCF 20121 Define processing error err-num on DEFINEADD of
define-name.
SCF 20122 Define processing error err-num on DEFINESETATTR of
define-name.
SCF 20125 Invalid device configuration for device name.