SCF Reference Manual for G-Series RVUs (G06.24+)

SCF Error Messages
SCF Reference Manual for G-Series RVUs—520413-004
B-34
SCF Error Messages
20312
Cause. The file code of the ZsubsysSCF file is not a valid type for a product module.
It must be either type 0 if it in TABLEPM format; otherwise, it must be type 100.
Effect. SCF waits for the next command.
Recovery. Contact your service provider, as described under If You Have to Call Your
Service Provider on page B-2.
20313
Cause. Because of file-system error err-num, the program file name is invalid.
Effect. SCF waits for the next command.
Recovery. Refer to the Guardian Procedure Errors and Messages Manual for
recovery from the file-system error. Then retry the command.
20314
Cause. An internal software error occurred on a call to PROCESS_CREATE_.
Effect. SCF waits for the next command.
Recovery. As described under If You Have to Call Your Service Provider on page B-2,
save pertinent information and contact your service provider.
20315
Cause. An internal software error occurred on a call to PROCESS_CREATE_.
Effect. SCF waits for the next command.
Recovery. As described under If You Have to Call Your Service Provider on page B-2,
save pertinent information and contact your service provider.
SCF 20312 pm-name Product module has incorrect format.
SCF 20313 PROCESS_CREATE_ error 1: File system error err-num
occurred on program file name.
SCF 20314 PROCESS_CREATE_ error 2: Parameter error on
parameter number.
SCF 20315 PROCESS_CREATE_ error 3: Bounds error on parameter
n.