SCF Reference Manual for G-Series RVUs (G06.24+)

SCF Error Messages
SCF Reference Manual for G-Series RVUs—520413-004
B-55
Common Error Messages
-00044
Cause. The new resource specified in a SWITCH command does not match the
configured backup resource for the command object. For instance, this error is issued
if a SWITCH command specifying a new processor number of 3 is directed to an object
running in processor 1 with a configured backup of processor 2.
Effect. SCF waits for the next command.
Recovery. Informational message only; no corrective action is needed.
-00045
Cause. The command cannot be applied to the object because a link exists between
the object specified in the command and some other object.
Effect. SCF waits for the next command.
Recovery. Informational message only; no corrective action is needed.
-00801
Cause. A specified TRACE parameter is invalid. The specified value could be out-of-
range or illegal.
Effect. SCF waits for the next command.
Recovery. Supply the proper value and retry the command.
-00810
Cause. An internal SCP TRACE error has occurred; specifically, an invalid link control
block (LCB) format has been detected.
Effect. SCF terminates.
Recovery. As described under If You Have to Call Your Service Provider on page B-2,
save pertinent information and contact your service provider.
subsystem {E|W}-00044 Switch to Wrong Resource.
subsystem {E|W}-00045 Links Exist.
subsystem {E|W}-00801 Invalid trace parameter specified for
object-name.
subsystem {E|W}-00810 Internal Error: SCP trace error;
invalid LCB format.