SCF Reference Manual for G-Series RVUs (G06.24+)

SCF Error Messages
SCF Reference Manual for G-Series RVUs—520413-004
B-59
Common Error Messages
-00846
Cause. The trace has failed. An internal Subsystem Control Point (SCP) trace error
has been encountered.
Effect. SCP terminates.
Recovery. Restart SCP and report the error to your service provider. See If You Have
to Call Your Service Provider on page B-2.
-00847
Cause. The TRACE target process responded incorrectly to a DEVICEINFO request.
Effect. The subsystem process terminates.
Recovery. Ask your system manager to restart the process for object-name; then
retry the command. If this attempt fails, contact your service provider, as described
under If You Have to Call Your Service Provider on page B-2.
-00848
Cause. A file-system error occurred when the TRACE collector attempted to initiate a
trace.
Effect. SCF waits for the next command.
Recovery. Stop the current trace, start a new trace, and report this error to your
service provider, as described under If You Have to Call Your Service Provider on
page B-2.
-00849
Cause. The TRACE collector cannot be opened because a prior TRACE command is
pending.
Effect. SCF waits for the next command.
Recovery. Wait a few seconds and retry the request.
subsystem {E|W}-00846 Internal Error: SCP trace error
encountered.
subsystem {E|W}-00847 Trace target process object-name
responded improperly to deviceinfo.
subsystem {E|W}-00848 Internal Error: Trace collector error.
subsystem {E|W}-00849 TRACE START is pending; retry trace
operation.