SCF Reference Manual for G-Series RVUs (G06.24+)

D-Series and G-Series Comparison and Migration
SCF Reference Manual for G-Series RVUs—520413-004
C-10
PUP-to-SCF Conversion Guide
PUP-to-SCF Conversion Guide
For G-series RVUs, you must convert Peripheral Utility Program (PUP) commands to
SCF commands. This subsection explains how D-series PUP commands correspond
to G-series SCF commands.
PUP Command Conversion
Table C-6 lists each PUP command and its equivalent SCF command. The SCF
Reference Manual for the Storage Subsystem contains further configuration
information.
Table C-7. Comparison of PUP and SCF Commands (page 1 of 2)
PUP Command SCF Command
CHECKSUM CONTROL DISK, CHECKSUM
DOWN [!] STOP DISK [,FORCED]
DOWN, HARD ABORT DISK
LABEL newvol, oldvol ALTER DISK oldvol, LABEL
newvol
LISTBAD INFO DISK, BAD
LISTCACHE INFO DISK, CACHE
LISTCACHE, INIT[IALIZE] STATS DISK, RESET
LISTCACHE, STAT[ISTICS] STATS DISK
LISTDEV STATUS DISK, DETAIL
STATUS TAPE, DETAIL
LISTDEV [ , STATUS , DETAIL ] REPEAT STATUS; DELAY
LISTDEV TYPE n [ , subtype ] LISTDEV TYPE n [ , subtype ]
LISTLABEL [ , DETAIL ] INFO DISK, LABEL
LISTLOG, {ADDED|MANUF|BOTH} INFO DISK, LOG
PRIMARY PRIMARY or SWITCH
REBUILDDFS CONTROL DISK, REBUILDDFS
REFRESH CONTROL DISK, REFRESH
RENAME ALTER DISK, {ALTNAME|VOLNAME}
RENAME, PERMANENT RENAME DISK
REPLACEBOOT CONTROL DISK, REPLACEBOOT
REVIVE START DISK
REVIVE, num,int ALTER DISK REVIVEBLOCKS num,
REVIVEINTERVAL int;
START DISK