SCF Reference Manual for G-Series RVUs (G06.24+)

D-Series and G-Series Comparison and Migration
SCF Reference Manual for G-Series RVUs—520413-004
C-20
Using MIGSCF in Command-Line Mode
are converted to the following SCFIN01 output file:
2. The following command converts a PUP command file named PUPIN to an SCF
command file named SCFIN02:
>MIGSCF / IN PUPIN , OUT RPT02 / -P SCFIN02
The contents of this PUPIN input file:
are converted to the following SCFIN02 output file:
3. The following command converts the PUP and COUP commands in a TACL
command file named OBEYIN to SCF commands in a file named SCFIN03:
>MIGSCF / IN OBEYIN , OUT RPT03 / -O SCFIN03
The contents of this OBEYIN input file:
COMMENT MIGSCF converted \CB6.$DATA.PAT.COUPIN on 28MAR97 14:20 PM
COMMENT COMMENT This is a sample COUP input file
COMMENT COMMENT 5516 printer on a 3605 controller
COMMENT ASSUME CONTROLLER
COMMENT SET PRODUCT 3605
COMMENT SET PRIMARYCPU (CPU 0, CHANNEL 3, ADDRESS %50)
COMMENT SET BACKUPCPU (CPU 1, CHANNEL 3, ADDRESS %40)
COMMENT ADD C3605A
COMMENT ADD PATH P3605A, PRIMARYCIU C3605A
ASSUME DEVICE
COMMENT SET MACRO ASYNCTERMPROC
COMMENT SET PATHNAME P3605A
COMMENT SET LIU 1
COMMENT SET PROGRAM $SYSTEM.CSS01.C9322P00
COMMENT SET SUBDEV1 (PRODUCT 5515, NAME #PTR15A)
ADD PROFILE $ZZWAN.#PATP5515, FILE $SYSTEM.SYSnn.PATP5515; ADD DEVICE $ZZWAN.&
#P5515A, ALTCPU 1, CPU 0, IOPOBJECT $SYSTEM.SYSnn.OATPCSS, PROFILE $ZZWAN.&
#PATP5515, TYPE (53, 0), RSIZE 1, PROGRAM $SYSTEM.CSS01.C9322P00, ADAPTER &
concname, CLIP clipnum, LINE linenum, PATH clippath
COMMENT Sample PUP input file
CONSOLE, $0
PRIMARY $DISK01, 0
COMMENT MIGSCF converted \LOCAL.$SYSTEM.OPCMDS.PUPIN on
30MAY97 10:35 AM
COMMENT Sample PUP input file
COMMENT CONSOLE, $0
PRIMARY DISK $DISK01 , 0
COMMENT Sample command file
PUP /IN PUPCMDS/
PUP CONSOLE, $0
\REMOTE.PUP /IN MYFILE/
COUP INFO $SYSTEM, DETAIL