SCF Reference Manual for G-Series RVUs (G06.24+)

D-Series and G-Series Comparison and Migration

SCF Reference Manual for G-Series RVUs—520413-004

C-22

Using MIGSCF in Batch Mode

Following is the RPT03 conversion report for the OBEYIN conversion in Example 3 on

page C-20.

Using MIGSCF in Batch Mode

You can convert multiple command files of COUP or PUP commands to corresponding

files of SCF commands. The syntax is:

MIGSCF T5816D44 (31MAY97) 28MAR97 14:15 PM

This software is an unsupported tool, and is Tandem Computers Incorporated

proprietary and confidential information.

Input file: \CB6.$DATA.PAT.OBEYIN

Output file: \CB6.$DATA.PAT.RPT03

Conversion mode: OBEY

New: COMMENT MIGSCF converted \CB6.$DATA.PAT.OBEYIN

on 28MAR97 14:15 PM

Copied: comment sample obey file

Old: PUP /IN PUPCMDS/

New: SCF /IN PUPCMDS/

* WARNING 656 * Command may refer to an unconverted command file.

Old: PUP CONSOLE, $0

New: COMMENT PUP CONSOLE, $0

* WARNING 205 * The PUP CONSOLE command is no longer supported. Use EMSDIST

instead.

Old: \REMOTE.PUP /IN MYFILE/

New: \REMOTE.SCF /IN MYFILE/

* WARNING 656 * Command may refer to an unconverted command file.

* WARNING 653 * Command invokes a remote copy of PUP.

Make sure the remote system is below the G-series.

Old: COUP INFO $SYSTEM, DETAIL

New: COMMENT COUP INFO $SYSTEM, DETAIL

* ERROR 367 * Missing object type.

File Conversion Summary:

Old commands read: 5

New commands written: 6

MIGSCF / IN filelist [ , OUT rptfile ] / -B [S]