SCF Reference Manual for G-Series RVUs (G06.24+)

Using SCF to Configure and Manage NonStop
S-Series Servers
SCF Reference Manual for G-Series RVUs—520413-004
1-18
Controlling G-Series Objects From a System
Running D-Series
To manage a system running G-series from a system running D-series, you must log
on to the G-series system and run that newer version of SCF. For example:
\D40> \G00.TACL
> LOGON
> PASSWORD
\G00>
You could change systems within SCF by using a command like the following:
\D40-> SYSTEM \G00
This situation is illustrated in Figure 1-7.
But doing this gives you ready access only to old subsystems (such as Expand and
X25AM). You will not have access to the new SCF commands and subsystems on the
system running G-series, because you do not have the necessary product modules on
the system running D-series. And you would not be able to use PUP or COUP on any
G-series objects.
Figure 1-7. Remote Connections Permitted From a System Running D-Series
SCP
$ZNET)
System Running
G-Series
VST010.vsd
Expand
Subsystem
X25AM
Subsystem
$ZZKRN $ZZWAN
System Running
D-Series
SCF
SCP
$ZNET)
Expand
Subsystem
X25AM
Subsystem