SCF Reference Manual for G-Series RVUs (G06.27+)

SCF Commands

SCF Reference Manual for G-Series RVUs—520413-005

5-26

ALLOW Command

The ALLOW command specifies the maximum number of warnings or errors allowed

during execution of a command file, an IN file, or a command that refers to multiple

objects. If the value is exceeded, SCF halts execution of the command file, IN file, or

multiple-object command. ALLOW affects only commands that issue multiple

commands or refer to multiple objects.

A typical use of the ALLOW command is to continue the execution of a startup

command file despite the occurrence of errors from inoperable lines or devices, which

would otherwise cause the execution of the command file to terminate. ALLOW would,

in such cases, allow the network to be started. The ALLOW command can be entered

interactively or from within a command file.

SCF error messages and warning messages are listed in Appendix B.

OUT file-spec

causes any SCF output generated for this command to be directed to the specified

file. The variable file-spec is defined on page 5-9.

ALL

indicates that there is no limit on the number of errors or warnings.

indicates that no errors or warnings are allowed.

count

is an integer specifying the number of errors or warnings permitted during the

execution of a command.

ERRORS

indicates that the command applies only to errors.

WARNINGS

indicates that the command applies only to warnings.

Considerations

•

If the ALLOW command is not used or if it is entered with no parameters, the

default setting is NO ERRORS and ALL WARNINGS.

ALLOW [ /OUT file-spec/ ] [ ALL ] [ ERRORS ]

[ NO ] [ WARNINGS ]

[ count ]