SCF Reference Manual for G-Series RVUs (G06.27+)

SCF Commands
SCF Reference Manual for G-Series RVUs—520413-005
5-35
ASSIGN Command
•
The assign message resulting from an SCF ASSIGN command supersedes any
same TACL ASSIGN command message that was read at SCF startup.
•
The assign messages set in SCF are lost when you exit from SCF.
•
If actual-file-name is omitted but create-open-spec is included, blanks are
passed in the actual-file-name field of the assign message.
•
If the Break key is pressed during an SCF session and a new assign message is
set outside of SCF, SCF does not receive this assign message. Therefore, SCF
does not pass on this new assign message when it creates a process.
Examples
•
The following command assigns the content of the file named $NEW2.T9082C30
to SSV0:
-> ASSIGN SSV0, $NEW2.T9082C30
•
The following command assigns the content of the file named
$GUESS.TOOLSC30.EXTDECS1 to EXTDECS:
-> ASSIGN EXTDECS, $GUESS.TOOLSC30.EXTDECS1
•
The following command displays all SCF assigns for the current session:
-> ASSIGN