SCF Reference Manual for G-Series RVUs (G06.27+)

SCF Commands

SCF Reference Manual for G-Series RVUs—520413-005

5-119

SWITCH Command

The SWITCH command causes the backup path object to become the primary path

object and, simultaneously, the primary path object to become the backup path object.

Path objects that can be switched between primary and backup are defined by each

subsystem. This is a sensitive command.

OUT file-spec

causes any SCF output generated for this command to be directed to the specified

file. The variable file-spec is defined on page 5-9.

object-spec

designates the object to be switched. The variable object-spec is defined on

page 5-2. If object-spec is omitted, the assumed object is switched. (See

ASSUME Command on page 5-36.) The objects that can be switched depend on

the subsystem.

SUB [ subobjtype ]

selects the subordinate objects the command affects. The variable subobjtype

can be a subordinate object type or one of the keywords ONLY, ALL, or NONE, as

explained under SCF Subdevices on page 3-5.

SEL [ NOT ] state

directs the command only at objects in the specified state or only at those not in

the specified state. Valid states are listed in Table 3-1 on page 3-7. The use of this

option is subsystem-specific.

attribute-name

is the name of a switchable attribute.

attribute-value

is the value associated with attribute-name to which the object should be

switched.

SWITCH [ /OUT file-spec/ ] [ object-spec ]

[ , SUB [ subobjtype ] ] [ , SEL [ NOT ] state ]

, attribute-name attribute-value