SCF Reference Manual for G-Series RVUs (G06.27+)

SCF Commands

SCF Reference Manual for G-Series RVUs—520413-005

5-129

VERIFY Command

This command tests an object for its ability to meet an object-specific subsystem

quality-control objective. For example, this command identifies defective sectors on a

disk.

This is a sensitive command.

OUT file-spec

causes any SCF output generated for this command to be directed to the specified

file. The variable file-spec is defined on page 5-9.

object-spec

designates the object or objects to be verified. The variable object-spec is

defined on page 5-2. If object-spec is omitted, the assumed object is verified.

(See ASSUME Command on page 5-36.)

attribute-spec

specifies an attribute and the value associated with the attribute. The attribute and

its value are defined by the subsystem that supports the VERIFY command. The

variable attribute-spec is defined on page 5-7.

VERIFY [ /OUT file-spec/ ] [ object-spec ]

[ , attribute-spec ]…