SCF Reference Manual for G-Series RVUs (G06.27+)
SCF Error Messages
SCF Reference Manual for G-Series RVUs—520413-005
B-12
SCF Error Messages
20052
Cause. A disk file has been created by SCF on your behalf.
Effect. SCF waits for the next command.
Recovery. Informational message only; no corrective action is needed.
20053
Cause. The specified product module refers to procedures that are not in the system
library object file and that have not been bound in.
Effect. SCF waits for the next command.
Recovery. If the ZsubsysSCF product module resides on $SYSTEM.SYSTEM or
$SYSTEM.SYSnn, contact your service provider, as described under If You Have to
Call Your Service Provider on page B-2. If you have used the PARAM SCF^PM^LOC
command to point to the product module, consult the author of the product module with
undefined externals.
20054
Cause. Too many processes are running on the system right now.
Effect. SCF waits for the next command.
Recovery. Use PEEK to verify that the system is locking too many process control
blocks to open this product module. Then contact your service provider, as described
under If You Have to Call Your Service Provider on page B-2.
20055
Cause. System resources are currently unavailable.
Effect. SCF waits for the next command.
Recovery. Try the command again. If the problem persists, contact your service
provider, as described under If You Have to Call Your Service Provider on page B-2.
SCF 20052 Creating file file-name.
SCF 20053 NEWPROCESS error 1: Process has undefined
externals.
SCF 20054 NEWPROCESS error 2: No process control block
available.
SCF 20055 NEWPROCESS error 4: Unable to allocate map.