SCF Reference Manual for G-Series RVUs (G06.27+)

SCF Error Messages
SCF Reference Manual for G-Series RVUs—520413-005
B-22
SCF Error Messages
20111
Cause. Too many object names were specified in a single command.
Effect. SCF waits for the next command.
Recovery. Split the object names into two commands.
Cause. Processing of the command file has been terminated because the maximum
number of errors set by the ALLOW command has been exceeded.
Effect. SCF waits for the next command.
Recovery. Either correct the conditions that cause the errors or increase the number
of allowable errors with the ALLOW command.
20113
Cause. Processing of the command file has been terminated because the maximum
number of warnings set by the ALLOW command has been exceeded.
Effect. SCF waits for the next command.
Recovery. Either correct the conditions that cause the warnings or increase the
number of allowable warnings with the ALLOW command.
20114
Cause. The ASSIGN/PARAM command or assign/param message cannot be
processed because the allocated space has been exceeded.
Effect. SCF waits for the next command.
Recovery. Use the CLEAR command to clear unneeded assign/param values. Then
retry the command.
SCF 20111 The size of the specified object names exceed the
allocated space.
SCF 20112 Maximum number of allowable errors exceeded.
SCF 20113 Maximum number of allowable warnings exceeded.
SCF 20114 ASSIGN/PARAM message exceeds allocated space.