SCF Reference Manual for G-Series RVUs (G06.27+)

SCF Error Messages
SCF Reference Manual for G-Series RVUs—520413-005
B-27
SCF Error Messages
20201
Cause. There are two object names in the object-name list that are exactly the same.
Effect. SCF waits for the next command.
Recovery. Delete the duplicate object name from the list. Then retry the command.
20202
Cause. A required parameter has been omitted in a procedure call.
Effect. SCF waits for the next command.
Recovery. As described under If You Have to Call Your Service Provider on page B-2,
save pertinent information and contact your service provider.
20203
Cause. An illegal value has been supplied as a parameter to a procedure.
Effect. SCF waits for the next command.
Recovery. As described under If You Have to Call Your Service Provider on page B-2,
save pertinent information and contact your service provider.
20204
Cause. The maximum length of the object name is longer than is supported by this
subsystem.
Effect. SCF waits for the next command.
Recovery. Retry the command, specifying a shorter object name.
SCF 20201 Duplicate object name in list.
SCF 20202 INTERNAL ERROR: Required Parameter missing on call
to proc.
SCF 20203 INTERNAL ERROR: Illegal value: n Call: proc
Param: param.
SCF 20204 Object name is too long.