SCF Reference Manual for G-Series RVUs (G06.27+)

Using SCF
SCF Reference Manual for G-Series RVUs—520413-005
4-14
Assigning the SCFCSTM Custom File
the file is to be executed. To use an SCFCSTM file at another location, enter the TACL
command shown below.
[[[\system.]$volume.]subvolume.]SCFCSTM
is the local or remote location of the SCFCSTM file.
Considerations
•
If the SCFCSTM file does not exist when you start SCF, SCF creates one to
reserve the file name. It contains only a comment.
•
The execution of the file is similar to an OBEY command with the NOECHO option.
That is, each SCF command is implemented without any output to the terminal.
•
If SCF is run on a remote system (for example, you issue the command
\REMOTE.SCF where \REMOTE is not your local system), SCF is not able to
locate the SCFCSTM file. You will receive a warning message stating that the
location of the SCF custom file cannot be determined. To provide remote
customization, specify either a local or remote SCFCSTM file in an ASSIGN
command entered before the \REMOTE.SCF command.
Examples
•
In this example, you assign an existing SCF custom file on your local system to the
SCF process running on a remote system named \REMOTE:
-> ASSIGN SCFCSTM, $DISK3.MYSUBVOL.SCFCSTM
-> \REMOTE.SCF
ASSIGN SCFCSTM, [[[\system.]$volume.]subvolume.]SCFCSTM