SCF Reference Manual for SCP

SCP PROCESS COMMANDS
START Command
START COMMAND
The START command initiates the operation of an SCP process.
Successful completion of the START command leaves the process
in either the STARTED or STARTING state. This is a sensitive
command.
The SUB and SEL options are not supported for the START command.
NOTE
The START command has meaning for SCP only when the
following are all true: a STOP,ORDERLY command has been
issued, the SCP process has not yet stopped, and it is
now desired that the SCP process should resume normal
operation.
The START command has the following object-spec :
object-type object-name
PROCESS SCP-process-name
2-8