SCF Reference Manual for the Kernel Subsystem

OBEYFORM
displays information about the SUBYS object in the format used in an ALTER SUBSYS command.
If you specify OBEYFORM, you cannot specify DETAIL.
INFO SUBSYS Considerations
Wild cards are not supported for the INFO SUBSYS command.
INFO SUBSYS Display Format
The format of the display for the INFO SUBSYS command is described here. See also the example
on page 108.
Note that if you use the ALTER command (described on page 85) to change the system name,
system number, or a time attribute, this change does not take effect until the next system load.
The INFO SUBSYS command lists any pending changed parameters at the bottom of the display.
NONSTOP KERNEL - Info SUBSYS $ZZKRN
*DAYLIGHT_SAVING_TIME................... { USA66 | TABLE | NONE }
*DESTINATION_CONTROL_TABLE.............. { SMALL | MEDIUM }
*NONRESIDENT_TEMPLATES..................
*POWERFAIL_DELAY_TIME ................ n
*RESIDENT_TEMPLATES..................... $vol.subvol.file
SUPER_SUPER_IS_UNDENIABLE.............. { ON | OFF }
*SYSTEM_NAME............................ \system
*SYSTEM_NUMBER.......................... n
SYSTEM_PROCESSOR_TYPE.................. NSR-x
*TIME_ZONE_OFFSET.......................
*TNSMISALIGN............................ { FAIL | NOROUND }
*TLE_LIMIT.............................. 2000
*AUTO_RETRY_ON_ERROR_654................ OFF
Pending Changes will take effect at next Manual Reload or Hard Reset of the system
*DAYLIGHT_SAVING_TIME................... {USA66 | TABLE | NONE}
*SYSTEM_NAME............................ \system
*SYSTEM_NUMBER.......................... n
*TIME_ZONE_OFFSET....................... [-]hh:mm
An asterisk (*) before an attribute name indicates that its attribute value can be changed with the
SCF ALTER command.
No asterisk before a name indicates that the parameter corresponds to an ALLPROCESSORS
paragraph entry in the CONFTEXT file. For detailed information regarding these parameters, see
the System Generation Manual for G-Series RVUs and the DSM/SCM User's Guide.
These terms apply to the preceding display:
The daylight-saving time algorithm used when the system clock is set: TABLE,
USA66, or NONE.
DAYLIGHT_SAVING_TIME
The size of the Destination Control Table: SMALL (32,767 entries) and
MEDIUM (65,376). If you used the ALTER command to reduce the size and
DESTINATION_CONTROL_TABLE
the reduction is incomplete because a number of logical devices (ldevs)
exceeds the requested size, INFO SUBSYS displays the requested size.
The location of the EMS nonresident template file. If $ZZKRN cannot find an
EMS template file on $SYSTEM.SYSTEM, it then searches for the file on the
current $SYSTEM.SYSnn.
NONRESIDENT_TEMPLATES
The maximum number of seconds after a power failure that the operating
system waits before initiating an orderly shutdown of the system.
POWERFAIL_DELAY_TIME
The location of the EMS resident template file. If $ZZKRN cannot find an
EMS template file on $SYSTEM.SYSTEM, it then searches for the file on the
current $SYSTEM.SYSnn.
RESIDENT_TEMPLATES
INFO Command 107