SCF Reference Manual for the Kernel Subsystem

err-num
is a file-system error number.
Cause
The specified file system error occurred during the WRITEREAD operation used for communication
between $ZZKRN and the $ZPM persistence manager.
Effect
Note that if the error is file-system error 40 (The operation timed out) and this occurred during
an ABORT or a START command, the command may have completed successfully. Use the
STATUS command to verify this. SCF waits for the next command.
Recovery
For an explanation of the file-system error, see the Guardian Procedure Errors and Messages
Manual. Then retry the command. If the problem continues, save pertinent information and
contact your service provider, as described under “If You Have to Call Your Service Provider”
(page 135).
00114
KRN 00114 Attribute attribute for
objname is not on the system-load volume.
attribute
is an object attribute.
objname
is the new name of a generic process, in the form $ZZKRN.#gpname.
Cause
The specified attribute is not on the system-load volume. This message may be either an ERROR
or a WARNING. If this is an ERROR, it is because it is a requirement that the attribute be on the
system-load volume.
Effect
SCF waits for the next command.
Recovery
If this is an ERROR, specify an attribute value that is on the system-load volume and retry the
operation. If this is a WARNING, be sure that this is the correct entry that you want for this
attribute (considering that it is not on the system-load volume), because this will not be checked
again other than through an attempted START. If this is not the entry you intend to use, use the
ALTER command to change to the appropriate entry.
00115
KRN 00115 File system error err-num occurred in
attempting SERVERNET operation.
err-num
is a file-system error number.
Cause
The specified file-system error was returned by the system library call used to attempt the
SERVERNET operation.
Effect
SCF waits for the next command.
Recovery
For an explanation of the file-system error, see the Guardian Procedure Errors and Messages
Manual. Then retry the command. If the problem continues, save pertinent information and
contact your service provider, as described under “If You Have to Call Your Service Provider”
(page 135).
168 SCF Kernel Subsystem Error Messages