SCF Reference Manual for the Kernel Subsystem

00116
KRN 00116 err-type error err-num occurred
in trying to read system values from the Service Processor.
err-type
is one of these error types:
DefinitionError Type
Unable to get the CRU handle of either service processor.Cruhandle Get
Unable to read from either service processor.FirFileRead
Unable to create the session with the service processor.Session Create
The service processor session has not been properly
terminated.
Session Destroy
err-num
is a file-system error number.
Cause
An error has occurred during an attempt to read the values for system name, system number,
daylight-saving time, and time zone offset from the service processor.
If you get this error in response to an ALTER command, the alter of these attributes is not carried
out, unless err-type is Session Destroy.
If you get this error in response to an INFO command, the Pending Changes for these values
could not be obtained, unless err-type is Session Destroy.
Effect
SCF waits for the next command.
Recovery
For an explanation of the file-system error, see the Guardian Procedure Errors and Messages
Manual. Then retry the command. If the problem continues, save pertinent information and
contact your service provider, as described under “If You Have to Call Your Service Provider”
(page 135).
00120
KRN 00120 Destination Control Table Resize support not available.
Cause
The Kernel Subsystem Manager ($ZZKRN) rejected the command because support for Destination
Control Table resizing is not present.
Effect
The command is not executed. SCF waits for the next command.
Recovery
Check to see that you have a version of the subsystem manager that supports Destination Control
Table resizing.
0121
KRN 00120 Destination Control Table Entries In Use.
Cause
When the Kernel Subsystem Manager ($ZZKRN) successfully executed the command to resize
the Destination Control Table to make it SMALL, some Destination Control Table entries outside
the range supported by a SMALL Destination Control Table were in use when the resize command
was executed.
SCF Error Messages 169