SCF Reference Manual for the Kernel Subsystem

Effect
SCF waits for the next command.
Recovery
This is an informational message only.
00122
KRN 00122 ALTER PROCESS failed: No changes were made.
Cause
The ALTER PROCESS command failed due to the causes described in the error messages
accompanying this message.
Effect
No changes are made to the system or to the System Configuration Database.
Recovery
Retry the operation after resolving the problems that the error messages indicate. If the problem
persists, save pertinent information and contact your service provider:
00123
KRN 00123 Insufficient Free Destination Control Table Entries would remain.
Cause
Some DCT entries (below the current DCT entry limit) must remain free for correct system behavior.
The DCT resize request you issued would leave insufficient free entries below the requested new
limit. Therefore, this DCT resize request has been rejected.
Effect
No changes are made to the system. SCF waits for the next command.
Recovery
Please retry the operation after there are sufficient free DCT entries below the requested new
DCT limit
00124
KRN 00124 Invalid combination of attributes was used.
Cause
You issued a command specifying one or more attributes inconsistent with one another.
Effect
SCF does not execute the command and waits for the next command.
Recovery
Issue this command to examine the command syntax:
HELP KERNEL command object-type
command
is a SCF KERNEL command.
object-type
is an SCF object type.
The HELP command gives information about the combination of attributes allowed with the
command. Resolve the attribute inconsistency.
00125
KRN 00125 Error err-num returned in response by $ZPM.
err-num
is the error number.
170 SCF Kernel Subsystem Error Messages