SCF Reference Manual for the Kernel Subsystem

NONSTOP KERNEL - Info SUBSYS \NONAME.$ZZKRN
Current Settings
*DAYLIGHT_SAVING_TIME ................ NONE
*NONRESIDENT_TEMPLATES................ $SYSTEM.SYSTEM.TEMPLATE
*POWERFAIL_DELAY_TIME................. 40
*RESIDENT_TEMPLATES................... $SYSTEM.SYSTEM.RTMPLATE
SUPER_SUPER_IS_UNDENIABLE............ OFF
*SYSTEM_NAME.......................... \NONAME
*SYSTEM_NUMBER........................ 44
SYSTEM_PROCESSOR_TYPE ............... NSR-W
*TIME_ZONE_OFFSET..................... 0:00
*TNSMISALIGN.......................... FAIL
*DESTINATION_CONTROL_TABLE............ SMALL
*TLE_LIMIT............................ 2000
*AUTO_RETRY_ON_ERROR_654.............. OFF
Pending Changes will take effect at next Manual Reload or Hard Reset of the system
*SYSTEM_NAME.......................... \EAST
*SYSTEM_NUMBER........................ 44
3. You can use the SCF ALTER command to change either of these attributes; for example:
-> ALTER, DAYLIGHT_SAVING_TIME USA66
-> ALTER, TIME_ZONE_OFFSET -5:00
If you are changing both attributes, you can more efficiently use system resources (because
these attributes are stored in a SEEPROM in the NonStop S-series server backplane) by grouping
them into one command rather than by entering each separately; for example:
-> ALTER, DAYLIGHT_SAVING_TIME USA66, TIME_ZONE_OFFSET -5:00
4. Confirm the change with another INFO command (shown below in bold type). The INFO
command displays both the current value and the changed (pending) value, which takes effect
at the next system load.
-> INFO
NONSTOP KERNEL - Info SUBSYS \NONAME.$ZZKRN
Current Settings
*DAYLIGHT_SAVING_TIME ................ NONE
*NONRESIDENT_TEMPLATES................ $SYSTEM.SYSTEM.TEMPLATE
*POWERFAIL_DELAY_TIME................. 40
*RESIDENT_TEMPLATES................... $SYSTEM.SYSTEM.RTMPLATE
SUPER_SUPER_IS_UNDENIABLE............ OFF
*SYSTEM_NAME.......................... \NONAME
*SYSTEM_NUMBER........................ 254
SYSTEM_PROCESSOR_TYPE ............... NSR-W
*TIME_ZONE_OFFSET..................... 0:00
*TNSMISALIGN.......................... FAIL
*DESTINATION_CONTROL_TABLE............ SMALL
*TLE_LIMIT............................ 2000
*AUTO_RETRY_ON_ERROR_654.............. OFF
Pending Changes will take effect at next Manual Reload or Hard Reset of the system
*DAYLIGHT_SAVING_TIME ................ USA66
*SYSTEM_NAME.......................... \EAST
*SYSTEM_NUMBER........................ 44
*TIME_ZONE_OFFSET..................... -05:00
5. Halt the system from the OSM or TSM Low-Level Link.
6. Reload the system using the Start System dialog box from the OSM or TSM Low-Level Link.
This action loads the millicode and puts the changes into effect.
NOTE: TSM is not supported in H-series and J-series systems.
Changing the System Time Attributes 33