SCF Reference Manual for the Storage Subsystem (G06.24+, H06.03+)

Configuring Magnetic Disks
SCF Reference Manual for the Storage Subsystem—529937-007
6-22
Altering Magnetic Disk Attribute Values
Altering Magnetic Disk Attribute Values
Use the ALTER DISK Command (page 14-51) to change configured attributes for
magnetic disks.
Considerations for ALTER DISK and Magnetic Disks
•
To change these attributes, first put the disk in the STOPPED state by using the
STOP DISK Command (page 14-148):
•
If a nonmirrored disk is in STARTED state, you can add a mirror drive by altering
the appropriate MIRROR and MBACKUP path attributes.
•
When changing these attributes, the IOP is not forced to stop:
•
To change the VOLNAME or ALTNAME attributes, see Naming a Magnetic Disk on
page 6-26.
•
When specifying attributes to add a physical volume to a storage pool:
°
The pool process and CATALOGLOCATION volume must be in the STARTED
state.
°
The CATALOGLOCATION volume must be protected by TMF.
•
When using the AUTOSELECT and PHYSVOLSELECT attributes:
°
The pool process and CATALOGLOCATION volume must both be in the
STARTED state.
°
The CATALOGLOCATION volume must be enabled by TMF.
°
The physical volume must be in the STARTED state.
ALTNAME MBACKUPLOCATION PRIMARYLOCATION
BACKUPDEVICEID MBACKUPPORTNAME PRIMARYLUN
BACKUPCPU MBACKUPSAC PRIMARYPORTNAME
BACKUPDEVICEID MIRRORDEVICEID PRIMARYSAC
BACKUPLOCATION MIRRORLOCATION PROTECTDIRECTORY
BACKUPPORTNAME MIRRRORLUN PROGRAM
BACKUPSAC MIRRORPORTNAME SERIALWRITES
HIGHPIN MIRRORSAC SQLMXBUFFER
LABEL PRIMARYCPU VOLNAME
MBACKUPDEVICEID PRIMARYDEVICEID
AUDITTRAILBUFFER LKIDLONGPOOLLEN NONAUDITEDINSERT
CBPOOLLEN LKTABLESPACELEN NUMDISKPROCESSES
FSTCACHING MAXLOCKSPEROCB OSSCACHING
HALTONERROR MAXLOCKSPERTCB