SCF Reference Manual for the Storage Subsystem (G06.24+, H06.03+)

Storage Subsystem Commands
SCF Reference Manual for the Storage Subsystem—529937-007
14-34
ADD PROFILE Command
AUDITTRAILBUFFER number
(TMF audit-trail volumes only) is the audit-trail buffer size (in megabytes) for an
audit volume. This value improves the performance of systems that use the
Remote Duplicate Database Facility. number is in the range 0 (no buffer specified)
through 768. The default is 0. Do not use this attribute for SQL/MX volumes.
If you specify too large or small a value, DP2 automatically sets the needed size.
If you specify a value of 0, DP2 automatically sets the size of the DP2 audit-trail
volume log cache, which defaults to 1 MB; that is, 256 audit-trail buffers.
AUTOLABEL { ON | OFF }
specifies whether to automatically label the disk when inserted into its slot. The
default is OFF.
This attribute is used only when you insert a nonlabeled disk into a slot where no
disk is currently configured.
If a disk was already configured in the slot, the inserted disk is not automatically
labeled. It can eventually receive a label in these ways:
•
The slot is half of a mirrored pair, the other half has a label, the other half is up,
AUTOSTART is ON, and AUTOREVIVE is ON. the label is copied from the
other half during the automatic revive operation.
•
The slot is half of a mirrored pair and the other half has a label, but one of the
other conditions in case 1 is not true. If you start the disk and respond “yes” to
the resulting question or questions, the resulting revive operation copies the
label from the other half.
•
You use the INITIALIZE DISK, LABEL command on the disk.
For information about using this attribute, see Considerations for LABEL and
Magnetic Disks on page 6-31.
AUTOREVIVE { ON | OFF }
(mirrored disks only) specifies whether to automatically start a revive operation on
a mirrored volume either when a new disk is inserted or when the system is loaded
and a mirrored volume is not synchronized.
For information about using this attribute, see Configuring Internal Mirrored
Magnetic Disks to Revive Automatically on page 6-13.
ON Automatically start a revive operation using the values for the
REVIVEBLOCKS and REVIVEINTERVAL attributes.
OFF Do not automatically start a revive operation (default).