SCF Reference Manual for the Storage Subsystem (G06.24+, H06.03+)

Storage Subsystem Commands
SCF Reference Manual for the Storage Subsystem—529937-007
14-100
DELETE DISK Command
DELETE DISK Command
The DELETE DISK command removes a magnetic or virtual disk from the system
configuration database. The syntax is:
Wild-card characters are not supported.
OUT file-spec
directs all SCF output to the specified file.
DISK $disk[-B |-M |-MB ]
is the disk name and, optionally, the path (backup, mirror, or mirror backup).
IGNOREINCONSISTENCY
specifies that a command can create an inconsistency between the system
configuration database and the SMF catalogs maintained by the SMF manager
process, storage pools, and virtual disks.
Use this attribute only if you understand SMF architecture and know how to restore
consistency between the system configuration database and the SMF catalogs.
The Softdoc for the T1083 product describes several inconsistencies and the
procedures for reconciling them.
POOL $pool
specifies that the command is performed only on disks associated with the
specified storage pool.
SEL state
specifies that the command affects only devices in the specified state.
SENDTO STORAGE
specifies that the command affects only disks of the specified type. The default is
ALL.
SUB { ALL | MAGNETIC | VIRTUAL }
specifies that the command affects only disks of the specified type. If not specified,
SUB ALL is assumed.
DELETE [ / OUT file-spec / ] DISK $disk[-B |-M |-MB ]
[ , IGNOREINCONSISTENCY ] [ , POOL $pool ]
[ , SEL state ] [ , SENDTO STORAGE ]
[ , SUB { ALL | MAGNETIC | VIRTUAL }