SCF Reference Manual for the Storage Subsystem (G06.24+, H06.03+)

Storage Subsystem Commands
SCF Reference Manual for the Storage Subsystem—529937-007
14 -111
INFO TAPE Command
SUBSYS $ZZSTO
is the storage subsystem manager.
INFO SUBSYS Consideration
The information showed by INFO SUBSYS and STATUS SUBSYS should always be
the same. If the information shown in these displays differs, contact your service
provider .
INFO SUBSYS Example
-> INFO SUBSYS $ZZSTO
See the display and explanation under Section 3, Using the Storage Subsystem
Manager.
INFO TAPE Command
The INFO TAPE command displays configuration information about a tape device.
The syntax is:
Wild-card characters are supported.
TAPE $tape
is the name of the tape device.
DETAIL
displays detailed configuration information.
OBEYFORM
displays information about the object in the format used in an ADD command.
SEL state
specifies that the command affects only devices in the specified state.
INFO TAPE Examples
•
To display information about a tape drive:
-> INFO $TAPE0
See the display and explanation under Example of an INFO TAPE Report on
page 13-3.
INFO [ / OUT file-spec / ] TAPE $tape
[ , { DETAIL | OBEYFORM } ] [ , SEL state ]