SCF Reference Manual for the Storage Subsystem (G06.24+, H06.03+)

Storage Subsystem Commands

SCF Reference Manual for the Storage Subsystem—529937-007

14-126

RESET Command

The RESET command puts an object in a state ready for starting.

RESET is a sensitive command.

RESET DISK Command

The RESET DISK command puts a disk into the STOPPED state, substate DOWN,

ready for restarting. It also can pause a disk revive operation. The syntax is:

Wild-card characters are supported.

OUT file-spec

directs all SCF output to the specified file.

DISK $disk[-P |-B |-M |-MB ]

is the disk name and, optionally, the path (primary, backup, mirror, or mirror

backup).

FORCED

terminates the IOP. If you use this attribute, you cannot specify a disk path (-P, -B,

-M, or -MB).

POOL $pool

specifies that the command is performed only on disks associated with the

specified storage pool.

SEL state

specifies that the command affects only devices in the specified state.

SUB { ALL | MAGNETIC | VIRTUAL }

specifies that the command affects only disks of the specified type. The default is

ALL.

RESET [ / OUT file-spec / ] DISK $disk[-P |-B |-M |-MB ]

[ , FORCED ] [ , POOL $pool ] [ , SEL state ]

[ , SUB { ALL | MAGNETIC | VIRTUAL } ]