SCF Reference Manual for the Storage Subsystem (G06.24+, H06.03+)

Storage Subsystem Commands
SCF Reference Manual for the Storage Subsystem—529937-007
14-127
RESET MON Command
RESET DISK Examples
See these procedures:
•
To reset the mirror half of a disk:
-> RESET $DATA00-M
•
To reset a virtual disk:
-> RESET $VDISK1
RESET MON Command
The RESET MON command puts the SMF master process into the STOPPED state,
substate DOWN, ready for restarting. The syntax is:
Wild-card characters are supported.
OUT file-spec
directs all SCF output to the specified file.
MON $ZSMS
is the SMF master process.
FORCED
terminates the IOP.
SEL state
specifies that the command affects only devices in the specified state.
RESET MON Consideration
The RESET command is ignored if the process is started.
RESET MON Example
See the procedure for Resetting the SMF Master Process on page 4-8.
To terminate the SMF master process:
-> RESET $ZSMS, FORCED
Resetting a Magnetic Disk 7-11
Resetting a Virtual Disk 10-13
RESET [ / OUT file-spec / ] MON $ZSMS
[ , FORCED ] [ , SEL state ]