SCF Reference Manual for the Storage Subsystem (G06.24+, H06.03+)

Storage Subsystem Commands

SCF Reference Manual for the Storage Subsystem—529937-007

14-128

RESET POOL Command

The RESET POOL command puts a storage pool process into the STOPPED state,

substate DOWN, ready for restarting. The syntax is:

Wild-card characters are supported.

OUT file-spec

directs all SCF output to the specified file.

POOL $pool

is the storage pool process.

FORCED

terminates the IOP.

SEL state

specifies that the command affects only devices in the specified state.

RESET POOL Consideration

The RESET command is ignored if the process is started.

RESET POOL Example

See the procedure for Resetting a Storage Pool on page 9-13.

To terminate the storage pool process:

-> RESET $POOL00, FORCED

RESET SCSI Command

The RESET SCSI command puts an Open SCSI device into the STOPPED state,

substate DOWN, ready for restarting. The syntax is:

Wild-card characters are supported.

RESET [ / OUT file-spec / ] POOL $pool

[ , FORCED ] [ , SEL state ]

RESET [ / OUT file-spec / ] SCSI $SCSI-device

[ , FORCED ] [ , SEL state ]