SCF Reference Manual for the Storage Subsystem (G06.24+, H06.03+)

Storage Subsystem Commands
SCF Reference Manual for the Storage Subsystem—529937-007
14-129
RESET TAPE Command
OUT file-spec
directs all SCF output to the specified file.
SCSI $SCSI-device[-P |-B ]
is the name of the Open SCSI IOP and, optionally, the path (primary or backup).
FORCED
terminates the IOP. If you use this attribute, you cannot specify a -P or B path.
SEL state
specifies that the command affects only devices in the specified state.
RESET SCSI Consideration
The RESET command is ignored if the process is started.
RESET SCSI Example
See the procedure for Resetting an Open SCSI Device on page 12-11.
To reset an Open SCSI device:
-> RESET $DEV0
RESET TAPE Command
The RESET TAPE command puts a tape drive into the STOPPED state, substate
DOWN, ready for restarting. The syntax is:
Wild-card characters are not supported.
OUT file-spec
directs all SCF output to the specified file.
TAPE $tape
is the name of the tape device.
FORCED
terminates the IOP.
RESET [ / OUT file-spec / ] TAPE $tape
[ , FORCED ] [ , SEL state ]