SCF Reference Manual for the Storage Subsystem (G06.24+, H06.03+)

Storage Subsystem Commands

SCF Reference Manual for the Storage Subsystem—529937-007

14-131

START Command

The START command initiates the operation of an object (make a stopped device

accessible to user processes). Successful completion of the START command leaves

the object in the STARTED state.

Supported objects are:

START is a sensitive command.

START DISK Command

The START DISK command makes a stopped disk accessible to user processes. If

needed, this command also revives the half of a mirrored volume that is in the

STOPPED state, substate DOWN. The syntax is:

Wild-card characters are supported.

OUT file-spec

directs all SCF output to the specified file.

DISK $disk[-P |-B |-M |-MB ]

is the disk name and, optionally, the path (primary, backup, mirror, or mirror

backup).

DEBUG $terminal

specifies that the process should start in debug mode on $terminal.

POOL $pool

specifies that the command is performed only on disks associated with the

specified storage pool.

SEL state

specifies that the command affects only devices in the specified state.

DISK page 14-131 SCSI page 14-134

MON page 14-132 TAPE page 14-134

POOL page 14-133

START [ / OUT file-spec / ] DISK $disk[-P |-B |-M |-MB ]

[ , DEBUG $terminal ] [ , POOL $pool ]

[ , SEL state ] [ , SPECIAL ]

[ , SUB { ALL | MAGNETIC | VIRTUAL } ]