SCF Reference Manual for the Storage Subsystem (G06.24+, H06.03+)

Storage Subsystem Commands
SCF Reference Manual for the Storage Subsystem—529937-007
14-135
START TAPE Command
OUT file-spec
directs all SCF output to the specified file.
TAPE $tape
is the name of the tape device.
DEBUG $terminal
specifies that the process should start in debug mode on $terminal.
SEL state
specifies that the command affects only devices in the specified state.
START TAPE Examples
See the procedure for Starting a Tape Drive on page 13-14.
•
To start all tapes available on the system:
-> START TAPE $*
•
To start a tape drive:
-> START $TAPE0